Collection: Graco LineLazer ES 1000 Parts

Common Repair Categories

• Batteries & chargers — replacement packs, charge cables, dock parts
• Pump service — packings, piston rods, seats, rebuild kits
• Filters & strainers — inlet strainer, gun filters
• Hoses & fittings — airless hose, whip hose, quick-disconnects
• Guns & tips — LineLazer guns, HD RAC tips, tip guards
• Wheels & drive — front caster, rear wheels, wheel bearings
• Seals & gaskets — pressure adjustment, o-rings, packing kits

Use the filter menu above the product grid to narrow by category.

Why Buy Genuine OEM from Pittsburgh Spray Equipment

• Genuine OEM parts shipped from Graco
• Same-day part ID help — text a photo of your machine's ID plate to (833) 670-5756
• Financing available on machines over $1,000
• Ships direct from stocked Pittsburgh warehouse

FAQ

What batteries does the ES 1000 use?
The Graco LineLazer ES 1000 runs on a proprietary Graco lithium-ion battery pack. Standard runtime is roughly a full day of typical property-maintenance striping on a single charge. Charge time from empty is a few hours on the included charger.

What are the pros vs cons of the ES 1000 vs a gas striper?
Pros: no fuel, no exhaust, quiet operation (indoor-safe for garages/warehouses), fewer wear items (no engine service). Cons: batteries eventually degrade and need replacement, and cold-weather runtime drops noticeably below 40°F. Best fit is property managers, small contractors, and indoor stripers.

Do LineLazer HD RAC tips fit the ES 1000?
Yes — the ES 1000 accepts the same LineLazer HD RAC tip family as Graco's gas stripers. Since the ES 1000 outputs lower pressure than the gas V-series, stick to smaller tip sizes (.011-.015) for clean line width.

How do I extend the ES 1000 battery life?
Store batteries at partial charge (50-70%), not fully depleted or fully charged, when the machine is out of use. Avoid leaving batteries in a hot truck bed in summer or freezing overnight in winter. Fully cycle the battery every 30-60 days if the machine sits idle.